Flexible Dexcom G4/G5 Receiver Case
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Flexible Dexcom G4/G5 Receiver Case
This is a flexible TPU case for a Dexcom G4/G5 receiver. This is a first attempt and still a WIP. I printed it with no supports because I thought they may be too difficult to remove after. It bridged pretty well and I was able to clean it up with a hobby knife. It could use some refinement, like rounded edges.
I used a Creality CR-20 Pro with the stock extruder. I used the following print settings.
Layer Height: 0.1mm
Shell thickness: 0.8mm
Retraction: disabled
Bottom/Top thickness: 1.2mm
Fill: 50%
Speed: 30
Printing temperature: 220
Bed temperature: 60
No supports
No rafts or brim
Flow: 100%
Initial layer thickness: 0.3mm
Initial layer line width: 150%
Travel speed: 80mm/s
Bottom layer speed: 15mm/s
All other settings are default.
Status | Rejected |
Support Free | YES |