Taz 5 Silicone Heated Bed Spring Replacement
This object has been checked for printability, but did not pass the test and was deemed not printable. This object is still shareable and people with this link will be able to see and download the object, so please make sure you watch out and progress with care!
×Taz 5 Silicone Heated Bed Spring Replacement
I saw some silicone bed spacers on amazon which were too big to use on the taz 5 so I created this mold and cast them myself. They work pretty well so far.
Hardware Required:
- 6x M3 x 20mm Screws
- 2x M3 Nuts
- Mold Max 60 or similar casting silicone
Print BedStandoff 2 times and put together using M3 screws and nuts. Clamp in the middle if possible to prevent leaking. Mix silicone, using a 10ml oral syringe insert silicone into tapered hole of mold until silicone starts coming out the hole in the bottom. Quickly insert an M3 screw through both holes to seal the mold and create the hole in the middle of the standoff.
Status | Rejected |
Support Free | YES |