Automatic light for Deathstar (ring) Box
Automatic light for Deathstar (ring) Box
Published 2023-01-17T15:28:27+00:00
This light will fit into the Deathstarbox by jsada_xvz (https://www.thingiverse.com/thing:3024053) printed in 70% of the original size.
The light automatically turns on when the Box is opened and the battery is recharable.
I've used this as a Ring box for a Wedding.
The Model consists of a bottom, a top and a recharger_housing (top and bottom).
You will additional need:
3x LED 3mm, round, red (https://www.ebay.de/itm/322611357869)
3x Resistor 220 Ohm
1x LiPo battery 3.7V, 100mAh ~18*15*7mm (https://www.ebay.de/itm/165589271463)
1x LiPo Charger Adafruit (https://www.ebay.de/itm/353545215847)
4x Magnet (https://www.ebay.de/itm/184713858657)
1x Tilt Ball switch d5x13mm (SW-520D)
1x aluminum foil
1x Acrylic glass milky/ clear
1x Deathstar Box printed 70% scale https://www.thingiverse.com/thing:3024053
1x Stand large (https://www.thingiverse.com/thing:216689)
cabel ca 30cm
foam
black fabric
the electric circuit is on the last picture. Solder everythin accordingly.
To assemble glue the LED into the three hole in the top part. The battery and the Tilt switch are glued onto the back of the top part. The aluminium foil is glued into the top part as a reflector.
The Acrylic glass was cut to size and sanded so it wasn't clear anymore. It is glued into the bottom part. Two of the Magnets are also glued into the square holes of the bottom part (caution polarity).
The charger and the last two magnets go into the recharger housing bottom (caution polarity). The recharger_housing just snaps together
The Magnets allow the Charger to connect only in the right polarty.
Cut two slits into the Foam and cover it in some black fabric and just push it into the Bottom of Box.
Date published | 17/01/2023 |
Support Free | YES |