Barbie quiver
Barbie quiver
Published 2021-10-05T17:15:13+00:00
This model was designed to complement the Barbie recurve bow (Faire Play Recurve Bow by zheng3). NOTE: This model does not include the bow.
The quiver can be printed without supports, in a vertical orientation.
The holes for the straps can easily accommodate 3mm (⅛") ribbon, craft leather or cording. The 'arrows' shown in the images are craft skewers with the tips sanded (for safety) and cut to approximately 11.5cm (4½"). The cavity holds 8 skewers comfortably. A small slit is cut into the end of the skewers so they can latch onto the cord on the bow.
IMPORTANT: Please use any 'arrows' cautiously with the bow, as I have discovered the projectiles can go quite far (almost 10m with good stringing!). They definitely should NOT be pointed at a person, because they could cause damage to eyes or other sensitive body parts.
Model dimensions
Height: 100mm (~4")
Outer diameter: 15mm (not including strap loops)
Internal cavity height: 95mm (~3¾")
Internal cavity diameter: 10mm
Sliced with PrusaSlicer at 0.15mm and 20% infill, this takes approx. 1hr 20mins to print (1hr at 0.2mm).
This is my first model, so feedback is welcome!
Printer: Artillery Genius Pro
Resolution: 0.15 or 0.2
Infill: 20%
Material: PLA (Flashforge Silk in 'Coffee')
Date published | 05/10/2021 |
Time to do | 60 - minutes |
Dimensions | 100mm x 15mm |
Support Free | YES |