I needed some "bench dogs" for my work bench, and I decided to see if I can print some that will hold up to the pressure of my woodworking. I also made it with 1 degree angle on the face to exert some downward pressure (in theory).
I made a couple prints of long one, and tested them on my bench. So far so good. The 20% infill felt a little light but held up, and the 80% infill was solid as a rock. I added slot and holes to maybe add some spring clips to hold it in place. However the print warped a little bit and it fits snugly in the holes.
These are meant for 3/4" dog holes on a woodworking workbench. You can buy metal ones, but I would rather use plastic or wood ones in case I hit it with my hand planes.
I made a short version that is printing now, and of course I put my name on them... because why not.