Classic Carrion Crawler (5 models)
$6.00 Classic Carrion Crawler (5 models)
Published 2021-06-21T15:18:23+00:00
A pack with 5 carrion crawlers (one of them dead) or similar grub-like beasties in 28-32mm scale. You can mirror them to get even more poses.
They come in pre-supported and unsupported versions. Of the former, models 1, 2, and 4 are already hollowed and with a hole since that helped the printing process (but they print either way.) Remember to let them drain and then plug the hole before curing (even if you forget and some resin leaks, it will on the underside so it will be hard to spot, though)!
Once cured, glue them to any suitable base you like, preferably after painting them because otherwise reaching the underside once glued to a base might be difficult. Keep in mind that, although some models are close to the ground, others, like model 2, are in more unbalanced or aggressive poses, so their center of gravity is off and they might not always stand on their own little legs (i.e., they may fall forward.)
I have included my printing settings below, but your default settings should work for these models and 0.05mm is the resolution I have used.
Layer Height: 0.05mm
Bottom Layer Count: 7
Transition Layer Count: 0
Exposure Time: 9s
Bottom Exposure time: 60s
Bottom Lift Distance: 6mm
Lifting Distance: 6mm
Bottom Lift Speed: 60mm/s
Lifting Speed: 60mm/s
Retract Speed: 150mm/s
Date published | 21/06/2021 |
Price | $6.00 |
Support Free | YES |