Classical Nude with Drapery
$4.00 Classical Nude with Drapery
3D
Published 2022-01-19T10:14:12+00:00
Full body classical figurine of a nude female with draped cloth. 1:10 (177mm) and 1:6 (300mm) scale files included (in the preview photos, the copper version is 1:6 and the gold version is 1:10).
Minimal supports required (see Printing Details).
The 1:6 version is provided cut and keyed. The 1:10 version prints as a single piece.
Please note the 1:6 version requires a minimum print height of just under 200mm to maintain the scale.
All STLs are provided in the orientations I used for my successful test prints, which were all done at 0.2mm layer height.
Full figure, 1:10 scale
This is designed to print as one piece, (mostly) without supports. The only supports needed were under the base and at the bottom of the fabric.
Lower body, 1:6 scale
This should print basically without supports. I did have supports turned on, because I forgot to turn it off, and I noticed there was a tiny amount of support material under the bottom edge of the fabric, and at the back of her foot, if I remember correctly. I used an 8mm brim and increased my build plate temperature by 5 degrees to ensure adhesion, since the print is extremely tall.
Upper body, 1:6 scale
Besides the supports required for the keyed bottom surface, support will also be needed under the chin, and I had a little support for the hair either side of the face. I used line supports with support interface, which left a blemish on the chest from the support for the chin. You might want to consider tree supports to avoid that.
Base, 1:6 scale
No support required. The model will free-stand without the base, but the base is recommended for stability.
| Date published | 19/01/2022 |
| Price | $4.00 |