The Duli 2.0 is finally here! This new design allows for maximum adjustability and comfort.
Print out and enjoy your favorite music, in the future!
These headphones are available fully assembled via our Etsy: http://etsy.me/1Bjy0fE
You'll need the following parts printed out to make these headphones:
Non-printed components: (available as a kit via tindie)
Foam pads x2
Speaker Jack x2
22 AWG wire
1/4" Audio Cable
Solder the speaker jack to the speaker, using a short length of 22 AWG wire. Snap the speaker into the duli_cup, and tighten the nut to attach the jack to the duli_cup.
Slide the foam pad over duli_cap, and then attach to duli_cup using two copies of pin1.
Insert both headband_bottom_geared into headband_top. Once inserted fully, attach top_gear and top_gear_pin.
Attach the duli_cup to the headband_bottom_geared using pin2.