Flesheater Barricade
$5.00 Flesheater Barricade
3D
Published 2021-07-01T16:16:30+00:00
SPAWNS OF THE GREAT ROT
Chapter: Ghuls
Subject: Flesheater Barricade
Description
These so-called barricades pop up everywhere, we aren't actually sure if the Ghulings just burrow underground and pop up somewhere else, or if they are manifested with blood magic. But if they catch you they will drag you underground, never to be seen again.
Details
This model comes with an unsupported and presupported version.
Get 40% discount on this model by joining my Patreon!
3D Elements Printing guide
- Models validated and supported for 50um LH (0,05mm)
- If you cannot print them on mono printers I suggest to increase cure time (even with fast resins even to 2.6s)
- I suggest 5 burn in layers (you can also add 2 transition layers)
- Raft is thin to prevent raft separation and resin wasting + FEP degradating
- If you struggle with removing supports please use warm water to make them soft then remove it
- Cure your model after removing supports and be gentle since some of the parts are thin.
General info of codes:
Presupported = heavy presupports
L-Presupported = Lighter version of supports
LL-Presupported = they are most lightly supported, working good with well calibrated printers, also leaving minimum ammount of scars on the model.
Hollowed versions only in LYS files.
Please consider to use them instead STL, they create less suction forces that means it minimise chance for failed print!
Cheers.
Happy Printing,
- Daniel Krasuski
| Date published | 01/07/2021 |
| Price | $5.00 |
