Flyingbear Ghost 5 upgrade kit
Flyingbear Ghost 5 upgrade kit
Published 2021-03-15T09:27:55+00:00
This is an upgrade kit for stock FBG5 printer.
You need:
1(2)pcs TMC2209 stepper motor driver
2pcs 4010 turbines
Lightweight NEMA17 17HS4023 steppermotor and a little soldering.
Use driver for Extruder motor (and Z axis optional). Keep in mind that drivers should be installed according to EN(able) pin! Otherwise you can burn driver and/or board. Also you need to invert axis direction anyhow and correct current accordingly. Motor should not be hot.
Petg is fine for all parts exept Nozzles. Endstop flag should be nontransparent. I put small piece of foil there.
Use ABS for Nozzles.
Chain and chain links should be printed 18pcs each
Used designs are:
- "Crab" by Sereggae (https://www.thingiverse.com/thing:4586854)
- Chain by BuckRogers61 (https://www.thingiverse.com/thing:4398459)
- Universal head by Seraggae (https://www.thingiverse.com/thing:4615328)
Most parts requires supports.
Be carefull while installing Universal printhead. Pay attention to small smd elements on pcb board. There is a video in Sereggae original post.
Important how you put thermoblock inside Printhead. Small bolts should be on sides. Check Serreggae's video twice.
Tips&tricks: for nozzle change you may unclick bottom front angle on left side as shown on photo. Then pull down left side of front blower nozzle. Front nozzle and turbine will be free.
Date published | 15/03/2021 |