Mini Guitar Amplifier
Mini Guitar Amplifier
Published 2019-08-11T13:45:11+00:00
This is a small model of a guitar amplifier. I´ve been following a one from Marshall.
For now this speaker is a bit too quiet, but while I was building it, I came up with an idea. So I´m planning an addition to this model, so the speaker will be louder.
So stay tuned for future uploads.
You can print the big part in one go, but I cut of the top section. So I was able to print the Overhangs better. But you can decide it.
The rest is very easy. Once you printed all the parts, finish them with a primer first and than paint them.
Take some superglue and stick a peace of fabric on to the Mountingplate and stick the 57mm speaker to the back of it.
Feed the cable with a 3,5mm jack through the hole of the housing and connect it to the speaker. After that, put everythnig toegether.
And you´re done!
Date published | 11/08/2019 |
Time to do | 660 - 720 minutes |
Material Quantity | 58g |
Dimensions | 80mm x 75mm x 40mm |