PPE Elastic Adjuster
PPE Elastic Adjuster
3D
Published 2020-04-12T04:35:14+00:00
The goal of this project was to reduce the strain on operaters ears while wearing masks. Because one size doesn't always fit all.
The PLA is thin enough to be flexable, without worrying about breaking. The buds on the inside are to help with slippage on hair/necks.
This little thing was requested by the local emergeny room. I based it off the design on the one that they had already, but wasn't able to find contact information to give them credit (see cover photo).
Printing 4 units at a time, resulting in 3hr 15min print time.
Printer: Ender 3
Software: Cura 4.4.1 software.
Material: PLA
Layer Height: 0.2 mm
Line Width: 0.4 mm
Wall Thickness: 1.2 mm
Top/Bottom Thickness: 0.8 mm
Infill Density: 25%
Infill Pattern: Gyroid
Printing Temp: 200 C
Bed Temp: 60 C
Wall Print Speed: 25 mm
Infill Print Speed: 50 mm
Travel Speed: 150 mm
Fan Speed: 100%
Support: N/A
Build Plate Adhestion Type: Skirt
| Date published | 12/04/2020 |
| Time to do | 49 - 50 minutes |
| Material Quantity | 20 grams |
| Dimensions | 160xmm149mmx3.5mm |
| Support Free | YES |
