Short Legs for Ikea Shelf to Table conversion
Short Legs for Ikea Shelf to Table conversion
3D
Published 2021-10-04T11:04:50+00:00
I was in need of a multmedia/audio center and had a Ikea book case lying around. I designed these legs to be sturdy and hopefully look stylish. The Legs were printed in PLA, maybe not the best for the long run but we will see. They were installed with 40mmx4mm screw with flat head and a bit of glue. The wood in the lower part of the Ikea shelve is almost non existant so I decided to also use the glue to secure them. The legs are 100mm tall, with lower part being 40 mm diameter and upper part 80mm of diameter.
Took around 3 hours with a 0.3 layer height and draft mode. Infill was reduced and external layer set to 4. This will give the print a lot of stability. The design itself is empty with a single column in the middle for support.
| Date published | 04/10/2021 |
| Time to do | 3 - 15 minutes |
| Material Quantity | 69g |
| Dimensions | 80mm*80mm*100mm |
| Support Free | YES |
