Solar Light Angled holder
Solar Light Angled holder
3D
Published 2019-08-05T18:41:46+00:00
Quick solar light holder I threw together. The pictures show it attached to a scrap board as I designed these as a gift that has not been delivered.
As a barbaric American who used the imperial system, the solar light shaft is 3/4". I rounded up to 20mm as I designed this in Tinkercad. The screw hole is 5mm with a 10mm hole in the front to allow the screw head to pass through and a small recess so that the screw head does not block the solar light from being held. I attached it to the board with a 3" exterior screw I had laying around.
ABS will have better weather resistance, but my test print was done in AIO Robotics PLA.
Sliced with Cura. 20% infil, Tree Supports used (projected time was slightly faster than traditional support)
Printed on Ender 3
| Date published | 05/08/2019 |
| Time to do | 180 - 200 minutes |
| Material Quantity | 20 |
| Dimensions | 30.0 x 40.5 x 74.8 |
