Square1 is a multi-layered maze in which the goal is to navigate a small marble through a series of 5 layers that make up a maze which is referred to as a ‘level’. But it’s not that simple. You don’t just have to direct a marble through a complex maze made of multiple layers, but you have to do it with a cover over the whole thing! There are 5 different levels included (with more to come) consisting of 5 layers.

Square1 is sure to keep you occupied and entertain for hours with its 5 pre-made levels (with more to come) consisting of 5 layers each. But the fun doesn't stop there! Once you beat all of the pre-made levels you can create your own levels to challenge yourself or share with friends with the layer template included in the files. Just export it to your favorite CAD software, draw the walls between each peg, and create a hole where you want the layer to end. Then just pop in your newly created maze!

To get started, just simply print out the Body, Bottom, and all of the layers for one of the levels and stack the layers onto of the base in the correct order/orientation with the first layer being on the top working down to the fifth layer. Then just put the marble in the upper left corner and put the cover on. The levels start out easier with just one hole in each layer so you don’t have to worry about turning the maze upside down, but once you get to level 5, things get a little more interesting. In level 5 you must turn the maze upside down to navigate back up to the previous layer through yet another hole and then back down to complete the maze!

If you just want to try out the maze without spending too much time printing, then just print the body, bottom, Level 1, and Level 5 to get a good idea about what this maze is like.

I will be publishing more levels as I get the time. Good luck completing Square1!

Printing

I recommend printing all of the parts at 10-20% infill.

The ball is tricky to print. I found success by printing at a slightly slower speed at 100% infill and a brim