Strength Test Probe
Strength Test Probe
Published 2020-03-23T18:53:50+00:00
I was trying to find a way to verify if my prints have enough Strength to Print basic mechanical parts. After several failed prints, I decided to print a basic shape that I can try to destroy as easy as twist it.
The idea is, to test Slicer settings, to see if the final print will have not just enough Strength, but also print quality, if warp and how much it does.
Measurements to compare with your print
100mm length
5mm height,
30mm width (holed side)
15mm width (narrow side)
18mm diameter (hole)
Printed at 60mm/s Print Speed. Consider just a feew lines of wall, I use 0.8, so that gives you between inner and out wall a total of 1.6mm. Four layers for Top and Buttom.
I printed the White probe at it's total height, and silver one with 3mm height. The Silver Probe was printed at 0.20 Leyer height and White one with 0.15 Layer height.
Date published | 23/03/2020 |
Time to do | 40 - 41 minutes |
Material Quantity | 7gm |
Support Free | YES |