SUP Vent Screw
SUP Vent Screw
Published 2016-02-18T11:29:39+00:00
Printable vent screw for stand up paddleboards*. It probably needs some o-ring grease* to get a watertight seal. I printed it at 100% infill. These don't have any cuts perpendicular to the threads, so they probably wont vent as rapidly as some of the others when partially loosened. I made these so I don't have to use surf wax next time I misplace my vent plugs.
I think there are a few different thread styles so I'm not sure which boards this design will fit. This design has a 1.5mm pitch and threads are approximately 12mm in diameter. The slot is sized to be tightened using a quarter.
I also added a threaded vent plug holder, made for attaching to a leash.
Printer:
-- Eustathios
Filaments: (full list can be found on thrinter)
-- eSun Red ABS
-- Sainsmart Transparent Red TPU
*affiliate link
*Exclusive sponsored gift by @Wesup included with this design.
Date published | 18/02/2016 |
Technology | FDM |