SW300-Aotrs 04 Murder Fightercruiser
$15.00 SW300-Aotrs 04 Murder Fightercruiser
Army Of The Red Spear
Murder Fightercruiser
Please note, to due the Murder's enormous size, it is only considered printable for FDM printers, thus no attempt has been made to hollow it out for resin or SLS printers; it should be considered closer to terrain than a vehicle. It may not even be suitable for all FDm printers. (It barely fits on the Prusa I3Mk3 and I would not have trusted a 24+ hour print on the Replicator myself!) Please check your printer is going to be big enough before purchasing!
Scale: 1:300th (6mm)
Size (Bounding Box): 264.0mm x 138.0mm x 95.36mm; Hull only (for printer size check)): 228.0mm x 125.82mm x 82.76mm
Locking turrets: Primary, secondary. The nose beam turret is further mounted so it can be (completely unnecessarily) swivilled to face any direction.
Supports: Not available at this time, sorry.
Mounting: 3.4mm diameter flight stand hole located at base; flight stand provided (note this is a 20mm stand, shorter than normal due to the Murder's size). The flight stand is entirely optional, however.
Scaling Notes: Yellow. Parts potentially affected by scaling: Flight stand hole, wall thickness, thin parts.
Entirely Optional Lore PDF included.
Photos of FDM print. (Prusa I3 Mk3)
Final photo demonstrates the fully mobile nose beam turret.
I recommend printing the hull by itself and the turrets afterwards. When printing the hull myself, I used Simply3D to split the process to print it at 0.2mm layer height until just below the flat of the hull top, did that in 0.1mm layer height, swtiched back to 0.2mm layer height until just below the top of the upper hull ridges and finished those of in 0.1mm layer height. I recommend a silimar approach to conserving printer time; the hull was 24 hours 47m even with this approach, it would likely be nearly 48 hours at 0.1mm layer height and the gain would be very minimal.
(The turrets can be printed at 0.1mm fine, that was only a 3 hour print done collectively on the Prusa.)
Status | Approved |
Price | $15.00 |