Sword Wall Hangers
Sword Wall Hangers
3D
Published 2018-03-06T17:11:51+00:00
This is a customizable wall mount hook set for displaying swords... or whatever you want to hang from hooks, I guess :) The way this is designed, the hook slides up behind the back plate. A screw is used to anchor both of these to the wall through the mounting hole. This is designed to accommodate #6 screw anchors. Then to cover the screw, a face plate is slid down over the back plate.
So far, I have only made two face plates - one with my signature hot pepper design, and the other with a calligraphic letter 'T', for Tombrello. I have included a blank plate for you to make your own design. If there is enough interest, I might be willing to do all of the letters of the alphabet myself.
There are two hooks. The smaller hook works well for swords with little to no protrusion of the hilt. My particular swords have a rather large diameter hilt, so I had to move them away from the wall a bit.
Pay no attention to the unfinished wall in the photos. That was the previous occupants "handiwork." I'll get around to repairing that later.
Printer:
Tevo Tarantula
| Date published | 06/03/2018 |
| Technology | FDM |
| Complexity | Easy |