I designed this tape holder system for my studio. For some mysterious reason, its difficult to find what you're looking for in 25+ rolls of tape?

They hang on a 8mm/0.33in diameter copper rod and there are 25mm/1in and 50mm/2in tapes versions.

Have fun organizing and check out what I'm up to on Instagram/@caraarndt :)

I printed them in ABS with 20% infill to allow for some flex but I guess a good PLA should be just fine. The holders can be printed flat side down with support to minimize support removal damage, and the brackets on the direction where the tube hole points up in order to maximize resilience to stress.

No commercial use please.