This is a toilet paper holder. You can use it to hold toilet paper. This is a good thing to have for when you have toilet paper, but nothing to hold it with.
This is a snap design so there's no need for springs.
Screw tp_left and tp_right into the wall side by side. tp_bar snaps in from the top.
To prevent the piece from breaking at the layers I used 3 shells. This is probably overkill.
You might need to drill out the holes a little, they ended up printing a bit smaller than I would have liked; I'll make a revision. Next time I'll probably also throw in a little recessed channel for the tp_bar to slide into so that it's easy to find the snap hole.
The 1 print tp file has an issue. Download 1 print tp (fixed) for the Replicator.
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
TP Holder by mikebattaglia is licensed under theAttribution - Non-Commercial - Share Alike license.