Twomp cartridge case
Twomp cartridge case
Published 2020-07-31T14:37:25+00:00
Cartridge case for the Nintendo Switch.
In order to design this case, the design of Handy_Dans_3D_Prints from Thingiverse was used (https://www.thingiverse.com/thing:2648592).
The primary changes are:
1. Added lid
2. Another layout of the storage
3. Removed gap in the print
Update 09/08/2020:
Added a version which uses 4 magnets (6 mm diameter, 3 mm height), because I didn't really like that you had to file off the part of the dots sticking out too much.
Note: This version hasn't been tested yet. So if it works please give a comment (also if it doesn't).
Instruction:
Can be printed at the settings you like, but supports are needed.
After printing, file off a part of the dots of the lid which are sticking out too much. Untill it snaps in the base.
Date published | 31/07/2020 |
Material Quantity | 60 grams |