This phone stand can support multiple styles of cables with the addition of the extra cable block insert. This can be customised for a friction fit for any cable by simply tweaking the scale or dimensions of the one supplied. It has been designed like this to allow for two things :
1) Insertion of the cable so that it can be secure and locked in place when pressing down and pulling out of the phone..
2) Given that friction fits are difficult to achieve, the cable block and cap solution doesn't require the reprint of the full model to trial and error the friction fitting.
Recommend double sided pads to hold the mount to the desk and is perfect for using whilst mounted and charging.
I use this on a Xiaomi Redmi 9 Note Pro which is a LARGE phone and it's incredibly stable, but results will vary based on how close the friction fit is.
Bare in mind that this was printed with some skewed values to allow for a larger than expected print due to the way the slicer and or printer layed down the plastic. I would recommend printing the stand, then customise the cable box insert to suit.
The cable block cap is cut on one side for cases which have a usb-c cover to allow a cap for it to fold out- again, this may not be applicable for your phone and in most cases this will not be a direct print.
Note: All STLs are printed as is except the cable block cap which needs rotating 180 degrees.
Please go nuts and rebuild this thing for your own phone!
Don't like G? Prefer L? Base too small? If you'd like to clone / tweak the raw files :https://cad.onshape.com/documents/6fb07c2bed2828987e5b289a/w/6998b82af3bce7a33e00b9e1/e/e2eb90e89c641838c921a2a1