WaterCan
WaterCan
Published 2018-07-10T17:14:13+00:00
This object was made in Tinkercad. https://www.tinkercad.com/things/bQNzFIbCbAp. This WaterCan is made for the Tinkercad Great Outdoors Design Challenge. The WaterCan is Designed to be printed in 4 parts then put togther to have a useable watercan for any home garden or indoor plants.
When all four parts are printed at full size screw the Nozzle on to the Spout, then screw the assembled Spout onto the can. The slide tha handle in to the grove on the back side of the can as you slide the top clip of the handle over the top rim of the can. Printing at smaller sizes may not give enough resolution to allow the parts to be fitted together properly.
Can is sized at 220mm x 220mm x 250mm My Printer will print 275 x 275 x 400 so I designed the can so it could be printed in a useable size, and had to make the can in 4 parts to be able to print the full WaterCan.
Printing Times
Can = 60 hours at full size
Spout = 7 hours at full size
Nozzle = 1 hour at full size
Handle = 3 hours at full size
using PLA
All parts printed at 50% size
Printing time = 20 hours
*** All Print Times are rounded up and will vary depending on printer settings. ***
All 4 parts can be aranged to fit on a 350 x 350 x 400 bed with a time of about 70 hours and 10 mins with 891 grams of PLA
Date published | 10/07/2018 |
Time to do | - 71 minutes |
Material Quantity | 891 grams |
Dimensions | 300 x 300 x 250 |
Technology | FDM |
Complexity | Easy |