choschiba's Print of Lion Statue ''Welcome''
Community Print 3D Print of Lion Statue ''Welcome''
Published 2019-05-08T10:38:09+00:00
1
0
Printed on: CraftBot 3D Printer
Material: PLA
Description
I printed it with 0.12mm layer height and resized it to 100mm. Unluckily I didn't get my setting 100% tuned in so the result has lots of spider webs. I printed it at 205°C which I think was a bit to high. 200°C might have been musch better.
I guess when you print it a bit bigger than I did it would come out much nicer.