larspoort's Print of Slim Credit Card Wallet
Community Print 3D Print of Slim Credit Card Wallet
Published 2021-04-11T18:23:10+00:00
0
0
Printed on: Creality Ender 3
Material: PLA
Description
Printed this in 5 hr for the frame and 30 min for the ejector.
I used a raft, because i was not sure if my bed adhesion would be enough for this small area on the bottom.
I lined the inside with the soft part of velcro that i cut down into thin strips. Works perfectly!
It is now easy to open, but also holds the cards well, only shaking it furiously will make the cards fall out.
Also, i made the lever stick out a bit more so i can open it with one hand ;)