Wetpotoo's Print of good model has been tested
Community Print 3D Print of good model has been tested
Published 2016-06-30T07:54:28+00:00
1
0
Printed on: Prusa I3 Geeetech
Material: PLA
Description
I printed it at what should be 1/4 the size of the file (about 12cm wide). With an in fill of 20% and a layer height of .15mm and a nozzle of .5mm. I had to cut off some of the bottom due to it not leveling properly. This did mess up the fabrics some but its not too bad. I could speed up my printer some but this was a 6 hour print.