Paladyne509's Print of Akiko, The Bounty Hunter [presupported]
462
views
0 comments
Loading comments...
Community Print 3D Print of Akiko, The Bounty Hunter [presupported]
Published 2023-01-15T10:16:17+00:00
2
0
Printed on: Anycubic Photon Mono X
Material: Resin
Description
Painted with a black base coat, then a burnt umber mixed with bronze powder (CuSn 320 mesh), then a watered down bright aqua green also mixed with bronze powder, then dry-brushed back over the top with the previous burnt umber mixture. I then dusted parts of it with a brush full of the bronze powder. It will patina a bit more until I seal it. I may decide to use some bronze rub-n-buff to add a bit of polish to some of the high-areas that would have been touched by hands if this were a large display statue. I also may go over this with a finishing wax… we’ll see.