This is a great model, but I am having incredible difficulty finding the right print orientation and slicer settings to get the hair to work. Currently, once I get about 10 layers in, my Ender 3 is depositing too much material at each end of the lowest piece of hair. This causes the hotend to touch the print, eventually rocking it loose from the support and the print failing. All the tree supports printing at the same time do not have this issue, and I am unsure of what settings in the slicer should be reviewed and adjusted to get this last piece to print. What suggestions are out there I should try? You can see the print beginning to get higher deposits at each end in the first picture, and I circled those same locations in red in the other. This rocks the print more and more until it breaks free at the point I circled in black.