lysithea81's Print of Shell Adhesive Tape Holder
Community Print 3D Print of Shell Adhesive Tape Holder
Published 2020-07-17T14:06:19+00:00
7
0
Material: PLA
Description
Printed half on my Ender and half on my FlashForge. The Ender did a far superior job.
50% infill, supports, rafts, 0.12mm resolution.
The serrations didn't print right so for the moment it doesn't dispense tape. I notice the serrations point slightly down instead of up like a regular tape dispenser... perhaps I can design and print an insert piece to glue into the gap...