Nyahm's Print of Flesh Mound [Pre-supported]
522
views
0 comments
Loading comments...
Community Print 3D Print of Flesh Mound [Pre-supported]
Published 2022-02-02T01:11:26+00:00
0
0
Printed on: Elegoo Mars 3
Material: Resin
Description
Using him to proxy a 'bone horror' monster in Descent 2e so printed him small. Was easy to print. The only issue I ran into is at the smaller sizes the supports became too thin and he would separate from them. Will tweak the supports so I can get him down to a size to fit on a 1x1 inch square.