cengizkalaycoglu's Print of The Mandalorian Support Free Remix Pose 3/5
379
views
0 comments
Loading comments... 
Community Print 3D Print of The Mandalorian Support Free Remix Pose 3/5
Published 2022-04-06T12:13:01+00:00
0
0
Printed on: Artillery Sidewinder X1
Material: PLA
Description
I've tried two times and failed, first of reason nozzle may touch to the foots while layers changing ,and if you did'nt use edge stick method it will seperate from table. second one is I did use two line for wall and not used z jump, and it have failed some prpoblem again. Finally I used 3 wall lines for each layer and set Z jump when layers change, and infill ratio is %0 ,only 3 line wall, and yes, it ihas finished.:) Before I forget I must say: I used some custom support for cloak.
ps: riffle lead has broke when I pull from the table