markaksel's Print of Bloodthirsty - Demons
425
views
3 comments
Loading comments... 
Community Print 3D Print of Bloodthirsty - Demons
Published 2022-07-20T14:27:37+00:00
1
3
Description
So what I did was orient the model as close as I could to your supported versions and supported myself. No fails (from what I can see). This is a ~13.5 hour print with 20 layer, so a misprint is quite annoying! =(
Let me check how hard my supports are to remove because yours came off like butter, so that was really nice! I would just consider beefing up a few supports on the end of the tail for my situation.