An easter display with a surprise inside
A multi-part print that assembles to an easter display. Print the lithophane in white. Be creative with the rest if you'd like.
Attach the flowers to the base either with the included flower center or with a small segment of 1.75mm filament that you clip off and smooth. Then put the lithophane in the shell, it will hold snugly, and place the lithophane in the slot and everything should hold without glue (though glue is an option).
Then hold the egg up to the light for a surprise inside.
Print at 0.2 mm layer height, with 10% infill. This uses 13 g of filament and takes 1 hour and 21 minutes.