josualuis's Print of Anycubic's Grand Tour Competition
Community Print 3D Print of Anycubic's Grand Tour Competition
Published 2021-10-30T19:52:58+00:00
4
0
Material: PLA
Description
The triumphal arch was the first model of a building / monumet that I printed (when I was just starting with 3d printing), I had it on my shelf for a long time until one day I ventured to take it one step further!
I decided to set the work in an indeterminate future, where humanity no longer inhabits the earth, but it is possible that there are some survivors.
Aditional Info:
-Measurements: Approximately * 6.5cm diameter * 6cm only the Arc de Triomphe and ground * 10cm with base include.
-Vegetation and Terrain: Expanded polystyrene, coated with "Pasta Das" and then add a layer of soil + pigments to give effects.
*Tree: colored foam rubber (commercial), trunk with copper wire.
*Grass: I used one that I make myself drying plants.
-Water: crystal resin + Mod Poge to give a textured effect and touch-ups with paint.
-Arc de Triomphe: painted white to later apply deterioration effects with washes and pigments.
-Printer: Flyingbear p905 and PLA